Contact Us
TEL: +86-755-89925302
Fax: +86-755-89929806
E-mail: sales@biadicable.com
Address: 1-5 Floors, No.2 Building, Tonglixing Industrial Park, No.8 Lanzhu East Road, Pingshan, Shenzhen, Guangdong
Home > News > Content
How To Convert From RJ45 To RJ11
Dec 03, 2018

Although RJ-45 and RJ-11 connectors are generally not compatible, there may be occasions when you can convert a cable with RJ-45 connectors to an RJ-11 jack. RJ-45 connectors are usually attached to a CAT-5 or Cat-5e cable with eight wires, commonly used in computer networking. RJ-11 is usually used with analogue telephone cable and has four wires. If you need to use a length of cable with RJ-45 connectors in an RJ-11 application, you can purchase an adapter. However, trying to convert an RJ-11 to an RJ-45 adapter is ill-advised, since there aren't enough wires and telephone wire isn't designed to accommodate the digital signals used in network cables.


Using the Adapter

Plug the male end of the adapter into the RJ-11 outlet, such as a phone connection. Plug one end of the RJ-45 cable into the adapter. Run the RJ-45 cable to the device you want to connect to the outlet. Plug another adapter into the RJ-45 outlet on the device. Plug the other end of the RJ-45 cable into the adapter connected to the device.

using1 using2


Replace Connectors

Use a pair of wire cutters to cut the RJ-45 connector off the end of the cable. Strip approximately 1 inch of the outer cable insulation to reveal four pairs of inner wires. Be careful not to accidentally nick the insulation on the inner wires. Untwist the four pairs of wires and arrange them from left to right starting with the white-and-green wire, followed by the white-and-orange wire, the solid blue wire, the white-and-blue wire, the solid orange wire and the solid green wire. Carefully cut off the solid brown and the white-and-brown wires so they're flush with the outer insulation. Hold the RJ-11 connector in your left hand with the plastic locking tab on the bottom.

re1 re2 re3


Insert the white-and-green wire into the hole in the connector closest to the left side. This is called "position one." Continue inserting the wires in order from left to right until all six wires are in place. The wire closest to the right side should be the solid green wire. Slide all the wires as far as possible into the connector so the insulation is flush with the rear of the connector. This is important since the unterminated wires must remain twisted, which helps to minimize signal interference. 


Insert the connector into the crimping tool and squeeze until the connector clicks together. Trim off any excess wire protruding through the front of the connector. Repeat the entire procedure for the other end of the cable.


Remark: Quoted from Rex Molder